![]() If you do not have any spare SATA data cable or extra SATA power plug from the power supply, you can borrow them from the Optical Drive, but be sure to return them after you finish. The computer will recognize the new hard drive immediately after the boot. The long plug is SATA Power connector that can be found from the Power Supply Unit, and the shorter one is for SATA Data cable that connects directly to the SATA Port on the motherboard.Īll you need in this scenario is just a SATA data cable. ![]() You should already notice there are two different connectors on the back of a SATA drive. All you need is paying close attention and proceed with care.įor Desktop Computer : If you are replacing the old drive with a new a 3.5″ Mechanical Hard Drive or 2.5″ Solid State Drive, you can connect it to the motherboard via one of the available SATA Ports. One mistake and it could stretch a very long way, you never want to lose all your precious data from a mis-click. You cannot simply drag and drop folders from old drive to a new one, it will not work because there are no boot records. In that case you will need to use a program that can take the exact snapshot of your current data drive and mount that identical image onto the new device.ĭuplicating hard drive content is a simple work unless if you do not have the right tool to work with, the disk cloning progress could be quite difficult. Most of the times you sure want keep all your files and folders intact during the upgrade, meaning data stay the same way they are on the new storage device as they were on the old one. If you are looking to replace your mechanical hard drive with a brand-new Solid State Drive or just want to upgrade to a larger capacity spinning-disk drive with your Operating System completely migrated, this article will show you several ways to get the job done :) ! ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |